Absolute
Quantitation of mRNA Species using Northern Blotting, Nuclease
Protection Assays and RT-PCR
Absolute quantitation measures the absolute
amount (e.g. 5.3 x 105 copies) of a specific mRNA
in an experimental sample. Dilutions of a synthetic sense strand
RNA (identical or very similar to the target template) are co-amplified
or detected along with the endogenous target. The sense RNA creates
a concentration curve to which the endogenously expressed message
is then compared in order to obtain an absolute measurement of
the transcript under study. Here, we discuss the use of such
synthetic sense-strand RNAs for absolute quantitation in Northern
blotting, nuclease protection assays, and RT-PCR.
Absolute Quantitation Using Northern Analysis
While Northern blotting is widely perceived
as being a valuable qualitative assay to obtain information about
mRNA expression, absolute quantitation by Northern analysis is
both possible and straightforward. A sense strand RNA transcript
complimentary to the probe is synthesized. This synthetic RNA
is quantitated, and dilutions are spiked into a yeast RNA background
and size fractionated in a denaturing agarose gel next to the
sample RNAs. Alternatively, a longer or shorter sense RNA, sharing
target sequence with the endogenous message, can be added to
the experimental samples. After blotting, the membrane is probed
with an antisense probe and the amount of endogenous target is
compared with the concentration curve generated by the synthetic
sense strand dilutions.
Figure 1 illustrates analysis of ß-actin
expression in various mouse tissues. For example, by comparing
the expression of ß-actin in mouse liver to the standard
curve derived in this experiment shows that there are approximately
30 pg of ß-actin RNA/µg of total mouse liver RNA.
|
|
| Figure 1. Quantitation
of Variable ß-actin Expression in Mouse Tissues. Mouse
total RNA from several tissues was run on a Northern
gel and transferred to membrane using Ambion's NorthernMax Kit.
Dilutions of full-length ß-actin sense RNA was
spiked into a yeast background and also run on the same
gel. A 32P-labeled antisense ß-actin
probe was used to detect ß-actin mRNA in the mouse
tissues as well as the artificial sense strand. Absolute
expression levels were determined by direct comparison
of the signal from the mouse tissues with the concentration
curve generated with artificial sense strand ß-actin. |
Absolute Quantitation of mRNA Species using Nuclease
Protection Assays
Different procedures exist for determining
the abundance of a particular mRNA in a heterologous RNA sample
using nuclease protection assays. Like in the Northern blotting
example above, a standard curve is constructed using known amounts
of in vitro synthesized "sense strand RNA" hybridized with an
excess of labeled antisense probe (See Figure 2). Experimental
samples are analyzed in conjunction with the control reactions
containing a titration of the unlabeled (or labeled to low specific
activity) sense strand RNA used to generate the standard curve.
The intensity of the probe fragments protected by the experimental
RNA samples can then be compared directly to the standard curve
and used to define the absolute amount of the target RNA species
present in the RNA samples.
|
|
| Figure 2. Detection
of Chloramphenicol Acetyltransferase (CAT) Expression
in COS Cells Transiently Transfected with pSVCAT. Increasing
dilutions of pSVCAT-transfected COS cells were assayed
for CAT mRNA by ribonuclease protection. Reaction products
were resolved on a denaturing 8% polyacrylamide gel,
dried, and autoradiographed. Lane 1, Century Markers;
lane 2 undigested CAT probe; lane 3, CAT probe digested
after hybridization with total RNA from 400,000 COS cells;
lanes 4-9, CAT probe digested after hybridization with
total RNA from 400,000, 200,000, 100,000, 50,000, 25,000,
and 12,500 transfected COS cells; lanes 10-14, standard
concentration curve generated by digestion of the CAT
probe after hybridization to 10, 20, 50, 100, and 200
pg of truncated sense transcript diluted in 5 µg
of yeast RNA. |
Synthesis of "Sense Strand RNA"
The synthetic sense strand transcripts used
for absolute quantitation of Northern blots and nuclease protection
assays can be made by linearizing the DNA template used for antisense
probe synthesis on the other side of the probe insert, and synthesizing
transcript from the opposite strand, provided that the insert
is flanked by opposable promoters. Use of an internal restriction
site for linearization will generate a "truncated" sense strand.
This may be desirable when the number of experimental samples
is large, since the concentration curve can then be added into
the experimental samples; i.e.. both natural sense strand and
artificial sense strand can be in the same tube. Figure 3 shows
an example of a sense strand concentration curve for a nuclease
protection assay using a truncated sense strand.
|
|
| Figure 3. Example
of a Standard Concentration Curve Generated with a Truncated
CAT Sense RNA. Ribonuclease
protection assays were performed on 10, 20, 50, 100 and
200 pg samples of a truncated CAT sense RNA diluted in
5 µg of yeast RNA. The reaction products were resolved
on a denaturing 8% polyacrylamide gel, and the protected
probe bands excised from the gel and Cerenkov counted
in a Beckman LS1801 liquid scintillation counter. |
Synthesis is usually performed in the presence
of all four unlabeled rNTPs (for RNA probes synthesized in in
vitro transcription reactions). Under these conditions, a large
mass of sense strand is made. A tracer amount of labeled nucleotide
is sometimes added to the four unlabeled ribonucleotides to aid
in calibration (see below). Sense strand made in this way with
or without label will be stable for at least several months.
Ambion's MEGAscript™ and MAXIscript™ Kits are ideal for this
purpose.
Gel Purification?
Sense strand molecules can be gel-purified.
However, since the sense strand is typically being synthesized
in the presence of high concentrations of all four rNTPs, transcripts
should be mostly full-length, and gel purification may therefore
not be necessary. DNase I can be used to degrade the DNA template.
In any case, it is at least a good idea to check the integrity
of the sense strand transcript on a gel before use. If gel purification
is desirable, the position of unlabeled transcripts can be determined
either
- by running a sample of the same-sized labeled antisense strand
probe in a neighboring lane and using its position;
- by UV shadowing of the bands; or
- by staining with EtBr or acridine orange.
Note that if dyes are used, they must be removed
after gel elution, since they can compromise hybridization to
the sense strand. UV shadowing involves placing the gel on a
fluor-coated TLC plate (Ambion Cat. # 10110G) and shining short
wavelength (254 nm) UV light onto the gel. Nucleic acids will
show up as purple bands. While this method requires no staining,
it does require a minimum of approximately 0.3-0.5 µg nucleic
acid.
Calibration of the Sense Strand
Exact quantitation of the sense strand transcript
is important to generate an accurate curve. The sense strand
can be quantitated by reading absorbance at OD260 or
by calculating yield based on the percent incorporation of a
radiolabeled tracer. 3H-nucleotides can be used for
this purpose although a small amount of 32P, 33P
or 35S radiolabeled nucleotides (e.g. 1 µl of
a 1:10 dilution of the stock labeled nucleotide, added to the
synthesis reaction in addition to the unlabeled form of this
nucleotide) will also work.
Standard Curve
To make a meaningful standard curve, the dilutions
of the sense strand should be made over the range of mass that
include the amount of target mRNA expected in the experimental
RNA samples. While moderately abundant mRNAs such as ß-actin
and GAPDH each make up as much as 3x10-4 the mass
of the original sample, a specific rare mRNA is usually present
at 1x10-9 to 1x10-6 the mass of the original
total RNA sample. I.e., for a 10 µg total RNA sample, there
may be 10 fg - 10 pg of a specific rare message.
Absolute or Competitive RT-PCR
Competitive RT-PCR precisely quantitates a
message by comparing signal intensity of the RT-PCR product to
a concentration curve created using a synthetic transcript or "competitor".
Competitors are designed to:
- be amplified using the same primers as the desired target
sequence,
- have the same amplification efficiency as the target sequence,
- be of a significantly different size from the target to allow
differentiation of the two products on an agarose gel, and
- control for variations in the RT reaction.
Ambion has two products that help researchers
meet all of these criteria: the RT-PCR Competitor Construction
Kit and the Competitive Quantitative RT-PCR Kits. Competitor
RNA transcript is synthesized, quantitated and diluted into the
sample RNA. Pilot experiments are run to determine the range
of competitor concentration where the experimental signal is
similar in concentration to the endogenous target. A more precise
concentration can then be determined by repeating the experiment
with a smaller dilution range, generating data that approximates
abundance of the endogenous target in the sample.
From the data illustrated in Figure 4 it can
be determined that between 1.5 - 3.05 x 106 copies
of hIL-10 RNA are present in the sample.
|
|
| Figure 3. Competitive
RT-PCR experiment. The
indicated amounts of hIL-10 Armored RNA® competitor
were added to 2 µg aliquots of experimental RNA,
and the mixture underwent RT-PCR. |
Products Available
Ambion offers a variety of internal
standards as linearized plasmid templates to generate antisense
RNA or DNA probes by in vitro transcription or primer extension.
These include human, rat and mouse templates for ß-actin,
GAPDH and cyclophilin and regions of 18S and 28S rRNA that cross
react with most vertebrates with few, if any, mismatches (Ambion's
18S rRNA template can be used with virtually any eukaryote).
All transcription templates (except pT7-18S-rRNA) are inserted
into our unique pTRIPLEscript vectors. pTRIPLEscript vectors
feature three tandem phage promoters which offer the researcher
the convenience of synthesizing an antisense RNA transcript using
either SP6, T7 or T3 polymerase. They are ideal for the synthesis
of antisense internal control standards and can be used in Northern
blots or as a second probe in ribonuclease and S1 protection
assays for simultaneous detection of both an internal reference
RNA and the mRNA being studied. Ambion also provides DECAtemplates for
making random-primed DNA probes for commonly used internal controls
(18S rRNA, ß-actin, GAPDH, and cyclophilin).
Along with our line of internal
control templates, we offer an extensive line of transcription
templates for human and mouse oncogene studies as well as high
quality mouse total RNA for RNA expression analysis. Ambion's
MAXIscript Kits are ideal for the transcription of high
specific activity antisense probes (MEGAshortscript Kits
are another option for transcribing large amounts of antisense
rRNA probes). RPA II and RPA III, and HybSpeed RPA Kits are also available for quick and
accurate analysis of RNA samples.
For accurate RT-PCR analysis,
we provide the QuantumRNA family of kits (with primer
and Competimer sets for 18S rRNA and ß-actin) for
relative quantitation, and the Competitive Quantitative RT-PCR
Kits (pre-made Armored RNA® Competitors for human interleukin
RNAs) for absolute quantitation. We also provide an RT-PCR Competitor
Construction Kit for synthesizing RNase-resistant RNA competitors
for RT-PCR.
Related Articles
|